These images are part of the wing assembly instructions
LOWER WING PHOTOS
Fitting all ribs to the spars
Ribs slipped in place and gluing crush plates
Gluing and clamping lower crush plates
Gluing and clamping butt fitting ply plates
Drilling drag wire holes
Drilling drag wire holes
Drilling drag wire holes
Fitting braces under walkway skin
Inside of upper walkway skin with braces varnished and ready for bottom skin
UPPER WING PHOTOS
Plywood angle braces for aseembling spars
Drilling spar splice plates and pinning with bolts
Spar splice components, trimmed, beveled and ready for glue
Apllying glue to spars, bolts hold center section in place
Spar splice glued and clamped using clamp blocks and bolts. Make sure spars stay in position and bolts stay perpendicular to
center spar face because clamp pressure on tapered spars will try to squish them apart
Front cabane fitting looking forward
Front cabane fitting looking aft
Rear cabane fitting looking forward
Rear cabane fitting and compression member looking aft